Freddy, Nov 2, To install a hard drive larger than gigabytes on your computer you need Windows Service Pack 3 or later or Windows XP Service Pack 1 or later. Combined capacity of all hard drives minus 1. Make sure you have the latest BIOS version for your desktop board. Should something happen to the RAID volume, the operating system should not be impacted. Fast read Fast write.
|Date Added:||5 September 2006|
|File Size:||61.46 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Better read Slightly degraded write. Go to the Boot menu.
If drives are not the same capacity, then the size will equal that of the d685perl drive. Save and exit the Bios Setup. After that, you can post your question and our members will help you out. A Performance as compared to single hard drive performance B Assumes all hard drives are of the same capacity.
Any Advice?? – Intel DPERL – 2 SATA drives – Cannot establish RAID 0 | PC Review
It’s a dark brown or black color. Freddy, Nov 2, Fast read Fast write. Thanks for all the information, I’ve read it.
Fast read Slightly degraded write.
Try a BIOS recovery. But, when I try to boot-up, it says: To install a hard drive larger than gigabytes on your computer you need Windows Service Pack 3 or later or Windows XP Service Pack 1 or later.
Combined capacity of 2 hard drives. F6 Driver Disk Note: I have no problem if drives are separate and not in RAID config. Switch the Drive Mode option from Legacy to Enhanced. While the Serial ATA controller may be operating at a higher transfer speed, it may claim to be operating in a slower d865;erl ATA transfer mode.
Enabling RAID in the BIOS for Intel® Desktop Boards
All drivers used are latest downloaded from Intel site. There should have been some procedure or order to install the RAID 0 array. Release Notes pdf OS: SATA 2 Raid question. Attach a cable end to the connector A on the board.
Select the Advanced menu, then the Drive Configuration menu. You’ll need to choose a username for the site, which only take a couple of moments here.
Downloads for Intel® Desktop Board D865PERL
RAID 5 without write-back cache. What color is your motherboard? Instead, later during Windows Setup, however, you will be prompted to insert the RAID driver floppy disk that came with the desktop board. See Intel page http: Switching modes may cause an “NTLDR” error, an immediate blue screen error followed by a reboot, or other boot failure. If your power supply does not include a SATA power connector, you will need an adapter.
Troubleshooting Serial ATA / RAID Issues
Some Serial ATA drives may require intrl power adapter cable. It uses slimmer cables, which improve circulation within the PC and keep the insides cooler. Fast read Non-optimized write.