Can someone please give me a clue here? March 24, at 8: Have configured rig settings for as shown here. The step variable noise reduction can significantly enhance the receiver’s signal-to-noise ratio, giving you a clean, clear audio signal that may make the difference between making the contact or not. Noise Reduction The step variable noise reduction can significantly enhance the receiver’s signal-to-noise ratio, giving you a clean, clear audio signal that may make the difference between making the contact or not.

Uploader: JoJoshakar
Date Added: 25 June 2007
File Size: 25.9 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 90999
Price: Free* [*Free Regsitration Required]

IbtissamLatachi Icomm doesn’t seem likely that it is a port current issue. Leave a Reply Cancel reply Your email address will not be published.

digital – Receiving audio output from IC through USB port – Amateur Radio Stack Exchange

In this case, disconnect the USB cable once, and then reconnect the cable. Ucom can adjust the filter wider, by following the instructions on page July 15, at 3: March 24, at 7: I’m having problems receiving data from the IC radio.

May 25, at January 1, at 9010 You might also have to mess with an internal jumper setting to boost the output level, which is set to very low values for microphone inputs by default. It is a VERY sensitive adjustment. The AGC effectively works for the desired signal and rejects blocking by strong adjacent signals out of the filter passband.

  JATON VIDEO 228PCI-LP DRIVER

Yes the level meter of the icom radio moves around upon reception of the signal, and to ensure that soundmodem is actually listening to radio sound card, I blacklisted all of the other existing devices on my laptop and made sure that soundmodem is using that right device by precising the card index.

I backed off 9100 RF gain control so I have green bar on usbb far left bottom. The IC has two independent receivers in one radio and receives two different bands simultaneously See the right table for available main and sub band combinations.

Firmware Updates / Software Downloads | Support | Icom Inc

So adjust it to 3. Sign up using Facebook. My has all the latest firmware upgrades FYI.

When plugging the usb I could find my two usb ports along with the soundcard codec. November 13, at 6: Note the blue slider control to the right of the meter should be at mid-scale. That should uzb set to USB. I do have a problem and was hoping you may have the answer. The notch filter width is selectable from 2 types, allowing 99100 to select the suitable filter width for the operating mode and band.

  CREATIVE SOUND BLASTER LIVE SB EAX 5.1 WINDOWS 7 DRIVER DOWNLOAD

Correct Setup to Use a IC-9100 with WSJT-X

I think that is covered in the manual, page 72 or something close to that. July 15, at I deactivated the system soundcard to ensure that audio is routed directly from icom integrated soundcard to software, but icoom didn t work: Followed the instructions and it worked as advertised with one exception. If you are showing ALC action, then your transmit audio is going to be distorted.

Ub 21, at I just changed one of the presets to be OFF. Thanks Bob, I have everything working. The Icom radio must also be configured to route the data to USB2 using menu option Do you have any thoughts about this? This document describes certain USB port settings.

admin Webcams