The scale must be calibrated if you proceed past this step. Using the Scale 3. Calibrate the scale Section 6 Note: Screw in all 4 feet, set upright and re-level Because the scale uses special low-power circuitry, no warm-up time is required.

Uploader: Fenrijora
Date Added: 6 May 2016
File Size: 38.64 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 65080
Price: Free* [*Free Regsitration Required]

Ultegra Flat Top (SCB-R)

Do NOT adjust all 4 feet. This manual also for: Page 11 Section 4: Computer Connections Section 2: General Information Page 6 – Section 2: Comments to this Manuals Your Name.

Using the level bubble, adjust one or two feet minimally to level scals platform. Verify all cables within the scale are down flush and will not contact the platform. Specifications Page 13 – Environment Page 14 – Section 6: Display Assembly Replacement Section 7: Page 15 Section 6: Zone Latitude degrees Reference City The maximum USB cable length is 5 meters unless a scale powered hub is used to extend the cable length.

To print the manual completely, please, download it. Page 2 Every effort has been made to provide complete and accurate information in this manual.


Parts Page 23 Page 24 – Appendix I: All equipment should be protected from direct sunlight. Repair and Parts Replacement If the corners are still not within one 1 division of each other, identify the corner s with the error and replace the load cell in that corner.

The scale may be placed on a desk, bench, or used with an ‘Insert’ adapter to countersink into a counter-top. Enter text from picture: Calibration Procedures -8, -7, -6, -5, -4, -3, -2, -1, 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 The breakdown of the zones are as follows: Calibrate the scale Section 6 Note: If the corners are not within one 1 division of each other, conduct a r9000 visual inspection to verify that there are no binds or interference with the platform and re test the scale.

Units may be ordered with a ball roller-deck surface. Sealing The Scale Section 6: Verify no weight is on the platform. Using the Scale 3.


Ultegra Roller Top (SCB-R)

Disconnect power to the scale 2. IF you are using a remote display, check the main display first, if it’s OK then check the cable and plug connection on the remote First unplug, then plug in the AC adapter to reset the program.

The breakdown of the zones are as follows: Remove the scale from the packing box and place on a flat surface where it will be used.

Scale will rr9000 “”, when power is turned on and weight is present. Weight readings will be accurate as soon as the unit is powered on and set to zero. Customer Care Page 11 Page 12 – Section 5: A low power USB device draws less than mA.

With the platform empty, press the [ZERO] key.

admin Monitors